Connections - Funkwerk W1002 Manual

6 Technical data
32
LED State
on (flickering)
on (flashing fast)
on (flashing fast)
ETH 1/2 off
on
on (flickering)
During the boot operation, all LEDs are on (1x red/green status and 4x green). This means
the monitor has been started and firmware is being loaded.

6.1.4 Connections

All the connections are located on the underside of the device. On bintec W1002n the third
antenna connection is located on the underside of the device. On bintec W2002 the third
and fourth antenna connections are located on the underside of the device. bintec W1002
and bintec W2002 have two Ethernet connections and one serial interface.
The connections are arranged as follows:
bintec W1002
Fig. 13: underside
Funkwerk Enterprise Communications GmbH
Information
At least one client is registered and
there is data traffic
BLD (Broken Link Detection) active
5 GHz scan active
No cable or no Ethernet link
Cable plugged in and link
Cable plugged in and link with data
traffic
bintec W1002/W1002n/W2002/WIx040/WIx065