Rip Filter - Funkwerk W1002 Manual

12 Routing
192
Field
Receive Version
Route Announce

12.3.2 RIP Filter

In this menu, you can specify exactly which routes are to be exported or imported.
You can use the following strategies for this:
• You explicitly deactivate the import or export of certain routes. The import or export of all
Funkwerk Enterprise Communications GmbH
Description
Decide whether routes are to be imported via RIP and if so, se-
lect the RIP version for receiving RIP packets over the interface
in receive direction.
Possible values:
• None (default value): RIP is not enabled.
• RIP V1: Enables sending and receiving of version 1 RIP
packets.
• RIP V2: Enables sending and receiving of version 2 RIP
packets.
• RIP V1/V2: Enables sending and receiving of both version 1
and version 2 RIP packets.
• RIP V1 Triggered: RIP V1 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
• RIP V2 Triggered: RIP V2 messages are sent, received
and processed as per RFC 2091 (triggered RIP).
Select this option if you want to set the time at which any activ-
ated routing protocols (e.g. RIP) are to propagate the IP routes
defined for this interface.
Note: This setting does not affect the interface-specific RIP con-
figuration mentioned above.
Possible values:
• Up or Dormant(default value): Routes are always propag-
ated.
• Active Only: Routes are only propagated if the interface
status is up.
• Always: Routes are always propagated independent of oper-
ational status.
bintec W1002/W1002n/W2002/WIx040/WIx065