Options - Funkwerk W1002 Manual

12 Routing
182
Field

12.1.2 Options

Back Route Verify
The term Back Route Verify describes a very simple but powerful function. If a check is ac-
tivated for an interface, incoming data packets are only accepted over this interface if out-
going response packets are routed over the same interface. You can therefore prevent the
acceptance of packets with false IP addresses - even without using filters.
Routing Routes
Fig. 81: ->
The Routing -> Routes -> Options menu consists of the following fields:
Fields in the OptionsBack Route Verify menu
Field
Mode
Funkwerk Enterprise Communications GmbH
Description
• Never dialup: The route can be used if the interface is
"up".
• Always dialup: The route can be used if the interface is
"up". If the interface is "dormant", then dial and wait until the
interface is "up". In this case, an alternative interface with a
poorer metric is used for routing until the interface is "up".
Options
->
Description
Select how the interfaces to be activated for Back Route Verify
are to be specified.
bintec W1002/W1002n/W2002/WIx040/WIx065