Ip Configuration - Funkwerk W1002 Manual

4 Basic configuration
18
Your PC should now meet all the prerequisites for the configuration of your device.

4.4 IP configuration

In the ex works state, your device is configured in DHCP Client mode and therefore dynam-
ically receives an IP address if you run a DHCP server in your network. If this is not the
case, connect your device directly to the configuration PC and use the fallback IP address
192.168.0.252.
Alternatively, you can assign your device the required fixed IP address by using the Com-
Point Manager.
To do this, install the program from the CD provided on your configuration PC.
Proceed as follows:
(a) Place the CD provided in the CD-ROM drive of your configuration PC. The installation
wizard should start automatically. If it does not, open the following file on the CD using
your file browser: starter.exe.
(b) Follow the instructions in the installation wizard.
Then carry out the following steps to configure an IP address for your device:
(1) Start the ComPoint Manager from the Windows Start menu: Start -> Programs ->
funkwerk -> ComPoint Manager.
The following dialog box appears:
ComPoint Manager
Fig. 7:
The ComPoint Manager detects the devices installed in the network.
(2) In the list, double click the MAC address of the device you want to configure.
If you do not know the MAC address of the device: A label containing the most im-
portant device data, including the MAC address, is attached to the device.
Funkwerk Enterprise Communications GmbH
initial screen
bintec W1002/W1002n/W2002/WIx040/WIx065