Analog Output Signal (Afm); Analog Output Gain - Delta VFD-B User Manual

Chapter 5 Parameters|VFD-B Series
03 - 10 Desired Frequency Attained 2
Settings
If a multi-function output terminal is set to function as Desired Frequency Attained 1 or 2
(Pr.03-00 to Pr.03-03 = 09 or 22), then the output will be activated when the programmed
frequency is attained.
master fr eq. attained
(output signal)
des ire d fr eq. attaine d
settin g 03 ze ro spee d indica tion
se tting 24 zero sp eed indi cation
03 - 05

Analog Output Signal (AFM)

Settings
This parameter sets the function of the AFM output 0~+10VDC (ACM is common).
03 - 06

Analog Output Gain

Settings
This parameter sets the voltage range of the analog output signal.
5-44
0.00 to 400.00 Hz
Fr equ ency
ma ster
fre quency
detection range
des ir ed
frequency
waiting time
for
freque ncy
run/s to p
OFF
ON
ON
out put timing chart o f m ultip le func tion ter minals
wh en setti ng to fr equ en cy at tain ed or z ero spe ed in di cation
00 Analog Frequency Meter (0 to Maximum Output Frequency)
01 Analog Current Meter (0 to 250% of rated AC motor drive current)
02 Output voltage (0 to Pr.01-02)
03 Output frequency command (0 to Maximum Frequency)
04 Output motor speed (0 to the Maximum Frequency)
05 Load power factor (cos90
01 to 200%
2Hz
ON
OFF
ON
O N
OF F
OF F
o o
to 0 )
Revision July 2008, BE16, SW V4.08 & V5.00
Unit: 0.01
Factory Setting: 0.00
detection
4Hz
range
dete ction
- 2Hz ran ge
D C br ake time
dur ing stop
Time
OFF
OFF
OFF
ON
ON
Factory Setting: 00
Unit: 1
Factory Setting: 100