Delta VFD-B User Manual page 149

Chapter 5 Parameters|VFD-B Series
Content
Status
monitor
Read only
5-92
Address
12: Current exceeds 2 times rated current during steady state
operation (ocn)
13: Ground Fault (GFF)
14: Low voltage (Lv)
2100H 15: CPU failure 1 (cF1)
16: CPU failure 2 (cF2)
17: Base Block
18: Overload (oL2)
19: Auto accel/decel failure (cFA)
20: Software protection enabled (codE)
21: EF1 Emergency stop
22: PHL (Phase-Loss)
23: cEF (Preliminary count value attained, EF active)
24: Lc (Under-current)
25: AnLEr (Analog feedback signal error)
26: PGErr (PG feedback signal error)
Status of AC drive
2101H
Bit 0-4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bit 10
Bit 11
Bit 12
Bit 13
Bit 14-15
2102H Frequency command (F)
2103H Output frequency (H)
2104H Output current (AXXX.X)
2105H DC-BUS Voltage (UXXX.X)
2106H Output voltage (EXXX.X)
2107H Step number of Multi-Step Speed Operation
2108H Step number of PLC operation
2109H Content of external TRIGGER
210AH Power factor angle
210BH Estimated torque ratio (XXX.X)
210CH Motor speed (rpm)
210DH PG pulse (low word) /unit time (Pr.10-15)
210EH PG pulse (high word) /unit time (Pr.10-15)
210FH Output power (KW)
2110H Reserved
2200H Feedback Signal (XXX.XX %)
Function
LED: 0: light off, 1: light up
00: RUN LED
01: STOP LED
02: JOG LED
03: FWD LED
04: REV LED
0: F light off, 1: F light on
0: H light off, 1: H light on
0: "u" light off, 1: "u" light on
1: Master frequency Controlled by communication
interface
1: Master frequency controlled by analog signal
1: Operation command controlled by
communication interface
1: Parameters have been locked
0: AC drive stops, 1: AC drive operates
1: Jog command
Reserved
Revision July 2008, BE16, SW V4.08 & V5.00