Summary Of Parameter Settings; User Parameters - Delta VFD-B User Manual

Chapter 5 Parameters|VFD-B Series

5.1 Summary of Parameter Settings

: The parameter can be set during operation.
Group 0 User Parameters
Parameter Explanation
00-00 Identity Code of
the AC motor drive
00-01 Rated Current
Display of the AC
motor drive
00-02 Parameter Reset
Start-up Display
00-03
Selection
Content of Multi
00-04
Function Display
User-Defined
00-05
Coefficient K
00-06 Software Version
00-07 Password Input
00-08 Password Set
00-09 Control Method
5-2
Settings
Read-only
Read-only
08: Keypad lock
09: All parameters are reset to factory settings
(50Hz, 220V/380V/575V)
10: All parameters are reset to factory settings
(60Hz, 220V/440V/575V)
00: Display the frequency command value (LED
F)
01: Display the actual output frequency (LED H)
02: Display the content of user-defined unit
(LED U)
03: Multifunction display, see Pr.00-04
04: FWD/REV command
00: Display output current (A)
01: Display counter value (C)
02: Display process operation (1.tt)
03: Display DC-BUS voltage (
04: Display output voltage (E)
05: Output power factor angle (n)
06: Display output power (P)
07: Display actual motor speed (HU)
08: Display the estimated value of torque as it
relates to current (t)
09: Display PG numbers/10ms (G)
10: Display analog feedback signal value (b)(%)
11: Display AVI (U1.) (%)
12: Display ACI (U2.) (%)
13: Display AUI (U3.) (%)
14: Display the temperature of heat sink (°C)
0.01 to 160.00
Read-only
00 to 65535
00 to 65535
00: V/f Control
01: V/f + PG Control
02: Vector Control
03: Vector + PG Control
Factory
)
u
Revision July 2008, BE16, SW V4.08 & V5.00
Customer
Setting
##
#.#
00
00
00
1.00
#.##
00
00
00