Analog Input / Output Parameters - Delta VFD-ED Series User Manual

Elevator drive
Hide thumbs Also See for VFD-ED Series:
Table of Contents

Advertisement

03 Analog Input / Output Parameters

Pr.
Parameter Name
 03-00 Analog Input 1 (AUI1)
03-01 Reserved
 03-02 Analog Input 2 (AUI2)
 03-03 Analog Input Bias 1
(AUI1)
03-04 Reserved
 03-05 Analog Input Bias 1
(AUI2)
 03-06 AUI1 Positive/negative
Bias Mode
03-07 Reserved
 03-08 AUI2 Positive/negative
Bias Mode
 03-09 Analog Input Gain 1
(AUI1)
03-10 Reserved
 03-11 Analog Input Gain 1
(AUI2)
 03-12 Analog Input Filter Time
(AUI1)
03-13 Reserved
 03-14 Analog Input Filter Time
(AUI2)
03-15 Load Compensation
Auto-tuning
03-15 Reserved
03-16 Reserved
 03-17 Analog Output Selection
1
Setting Range
0: No function
1: Frequency command (speed limit
under torque control mode)
2: Torque command (torque limit under
speed mode)
3: Load compensation
4–5: Reserved
6: P.T.C. thermistor input value
7: Positive torque limit
8: Negative torque limit
9: Regenerative torque limit
10: Positive/negative torque limit
-100.0–100.0%
-100.0–100.0%
0: Zero bias
1: Lower than or equal to bias
2: Higher than or equal to bias
3: Using bias as the base to get the
absolute value of bias voltage
(unipolar)
4: Using bias as the base (unipolar)
0.0–500.0%
0.0–500.0%
0.00–2.00 sec.
0.00–2.00 sec.
0: No function
1: Auto-tunes with running without load
2: Auto-tunes with running with load
0: Output frequency (Hz)
1: Frequency command (Hz)
2: Motor speed (RPM)
3: Output current (rms)
4: Output voltage
5: DC bus voltage
6: Power factor angle
7: Power factor
8: Output torque
9: AUI1
10: Reserved
11: AUI2
12: q-axis current
13: q-axis feedback value
14: d-axis current
15: d-axis feedback value
11-11
Ch11 Summary of Parameter Settings | VFD-ED
: You can set this parameter during operation.
Default
1
0
0.0
0.0
0
0
100.0
100.0
0.01
0.01
0
0

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents