Multi-Step Speeds And Plc (Process Logic Control) Parameters; Plc Mode - Delta VFD-B User Manual

Group 5: Multi-step speeds and PLC (Process Logic Control) parameters
05 - 00 1st Step Speed Frequency
05 - 01 2nd Step Speed Frequency
05 - 02 3rd Step Speed Frequency
05 - 03 4th Step Speed Frequency
05 - 04 5th Step Speed Frequency
05 - 05 6th Step Speed Frequency
05 - 06 7th Step Speed Frequency
05 - 07 8th Step Speed Frequency
05 - 08 9th Step Speed Frequency
05 - 09 10th Step Speed Frequency
05 - 10 11th Step Speed Frequency
05 - 11 12th Step Speed Frequency
05 - 12 13th Step Speed Frequency
05 - 13 14th Step Speed Frequency
05 - 14 15th Step Speed Frequency
Settings
The Multi-Function Input Terminals (refer to Pr.04-04 to 04-09) are used to select one of the
AC motor drive Multi-step speeds. The speeds (frequencies) are determined by Pr.05-00 to
05-14 as shown above. They are also used in conjunction with Pr.05-15 to 05-31 for PLC
programs.
05 - 15

PLC Mode

Settings
This parameter selects the mode of PLC operation for the AC motor drive. The AC motor drive
will change speeds and directions according to the desired user programming.
This parameter can be applied in the PLC operation of general small machines, food
processing machines and washing equipment.
Revision July 2008, BE16, SW V4.08 & V5.00
0.00 to 400.00 Hz
00 Disable PLC operation
01 Execute one program cycle
02 Continuously execute program cycles
03 Execute one program cycle step by step
04 Continuously execute program cycles step by step
Chapter 5 Parameters|VFD-B Series
Factory Setting: 0.00
Factory Setting: 00
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
Unit: 0.01
5-59