Table of Contents
Advertisement
02 Digital input / Output Parameters
Pr.
Two-Wire / Three-Wire
02-00
Operation Control
Multi-Function input
02-01
Command 1 (MI1)
Multi-Function input
02-02
Command 2 (MI2)
Multi-Function input
02-03
Command 3 (MI3)
Multi-Function input
02-04
Command 4 (MI4)
Multi-Function input
02-05
Command 5 (MI5)
Multi-Function input
02-06
Command 6 (MI6)
Parameter Name
Chapter 6 Descriptions of Parameter Settings
Settings
0: No Function
1: Two-wire mode 1, power on for operation control
(M1: FWD / STOP, M2: REV / STOP)
2: Two-wire mode 2, power on for operation control
(M1: RUN / STOP, M2: REV / FWD)
3: Three-wire, power on for operation control
(M1: RUN, M2: REV / FWD, M3: STOP)
0: No Function
1: Multi-step speed command 1
2: Multi-step speed command 2
3: Multi-step speed command 3
4: Multi-step speed command 4
5: Reset
6: JOG command
7: Acceleration / deceleration speed inhibit
8: 1
and 2
acceleration / deceleration time
st
nd
selection
9: 3
and 4
acceleration / deceleration time
rd
th
selection
10: External Fault (EF) input
11: Base Block (B.B.) input from external
12: Output stop
13: Cancel the setting of auto-acceleration / auto-
deceleration time
18: force to stop (Pr.07-20)
19: Frequency up command
20: Frequency down command
22: Clear the counter
23: input the counter value (MI6)
24: FWD JOG command
25: REV JOG command
28: Emergency stop (EF1)
38: Disable writing EEPROM function
40: force coasting to stop
41: HAND switch
42: AUTO switch
49: Enable drive
56: Local / Remote selection
6-1-9
Default
1
0
0
0
0
0
0
Advertisement
Table of Contents
