Output Function Parameters - Delta VFD-B User Manual

Chapter 5 Parameters|VFD-B Series
Group 3: Output Function Parameters
03 - 00 Multi-function Output Relay (RA1, RB1, RC1)
03 - 01 Multi-function Output Terminal MO1
03 - 02 Multi-function Output Terminal MO2
03 - 03 Multi-function Output Terminal MO3
Settings Function
00 No Function
01 AC Drive Operational
Master Frequency
02
Attained
03 Zero Speed
04 Over-Torque Detection
Baseblock (B.B.)
05
Indication
06 Low-Voltage Indication
Operation Mode
07
Indication
08 Fault Indication
Desired Frequency
09
Attained 1
10 PLC Program Running
PLC Program Step
11
Completed
12 PLC Program Completed
13 PLC Operation Paused
5-42
Active when there is an output from the drive or RUN
command is "ON".
Active when the AC motor drive reaches the output
frequency setting.
Active when Command Frequency is lower than the
Minimum Output Frequency.
Active as long as over-torque is detected. (Refer to Pr.06-03
~ Pr.06-05)
Active when the output of the AC motor drive is shut off
during baseblock. Base block can be forced by Multi-function
input (setting 9 or 10).
Active when low voltage(Lv) is detected.
Active when operation command is controlled by external
terminal.
Active when faults occur (oc, ov, oH, oL, oL1, EF, cF3, HPF,
ocA, ocd, ocn, GFF).
Active when the desired frequency (Pr.03-04) is attained.
Active when PLC Program is running.
Active for 0.5 sec each time the multi-step speed is attained.
Active for 0.5 sec when the PLC program cycle has
completed
Active when PLC operation is paused.
Factory Setting: 08
Factory Setting: 01
Factory Setting: 02
Factory Setting: 20
Description
Revision July 2008, BE16, SW V4.08 & V5.00