IBM pSeries 690 Service Manual page 613

Error Code Description
4069 0EB6 Attention line 5 stuck fault
4069 0EB7 Attention line 6 stuck fault
4069 0EB8 Attention line 7 stuck fault
4069 0EB9 Attention line 8 stuck fault
4069 0EBA Attention line 9 stuck fault
4069 0EBB Attention line 10 stuck fault
4069 0EBC Attention line 11 stuck fault
4069 0EBF Memory error
4069 0EE1 Memory tests detected fault in service
processor code (invalid MRU to mapping)
4069 0EE2 Memory tests detected fault in service
processor firmware fault
4069 0EE5 Memory tests detected firmware error; no
callout available
4069 25E6 SMA 4-port switch adapter fault
4069 273F SMA 2-port switch adapter fault
406A 0001 Self tests detected clock card assembly failure
406A 0002 Self tests detected backplane assembly failure
406A 0003 Self tests detected fault in MCM module 0
406A 0004 Self tests detected fault in MCM module 2
Action/
Possible Failing FRU
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
1. Reboot the system in slow mode to the
SMS menus. See "Performing Slow Boot"
on page 415.
2. Examine the service processor error log.
v If a CEC subsystem error (a 4xxx yyyy
error) occurred during the slow boot that
calls out the memory, processors, L3
cache modules, or the primary I/O book,
replace the part indicated by the location
code.
v If a CEC subsystem error (a 4xxx yyyy
error) did not occur during the slow boot,
look for a 4xxx yyyy error immediately
preceding the 406x 0EBF error. Replace
the part indicated by the location code
associated with that error.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
1. Check for system firmware updates.
2. Call service support.
Replace the I/O book (switch adapter) specified
by the location code.
Replace the I/O book (switch adapter) specified
by the location code.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
MCM module 0 and VPD card
Location: U1.18-P1-C1 and U1.18-P1-H2.3
MCM module 2 and VPD card
Location: U1.18-P1-C4 and U1.18-P1-H2.4
Chapter 5. Error Code to FRU Index
597