Removing A Pci Adapter Cassette - IBM pSeries 690 Service Manual

Removing a PCI Adapter Cassette

Attention: Perform this procedure only when you are instructed to by the removal and replacement
procedures in "Removing a Non-Hot-Pluggable PCI Adapter" on page 936 or "Hot-Pluggable PCI Adapter"
on page 937.
Note: An adapter or a blank filler must be installed into the PCI adapter cassette before it is reinstalled in
a processor subsystem or an I/O subsystem.
The following illustration shows the PCI adapter cassette.
1 PCI Adapter Cassette
2 Handle-Release Lever Latch
3 Locking Bar
4 Handle Release Lever
5 Handle
6 PCI Adapter Tailstock Tab
7 Adapter Cassette Pull Tab
Chapter 9. Removal and Replacement Procedures
931