Setup Remote Ipl (Initial Program Load) - IBM pSeries 690 Service Manual

Setup Remote IPL (Initial Program Load)

This option allows you to enable and set up the remote startup capability of your system or partition. A list
of NIC (network interface card) adapters in the system displays first. An example of this screen follows:
Attention: In a partitioned system, only those network adapters that have been assigned to the partition
being booted display in the IP Parameters menu. In a full system partition, all network adapters in the
system are listed in the adapter parameters menu.
NIC Adapters
Device
1. 10/100 Mbps Ethernet PCI Adapt
2. IBM 10/100/1000 Base-TX PCI
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
When an adapter is selected, the Network Parameters menu displays:
Network Parameters
10/100 Mbps Ethernet PCI Adapter II: U1.9-P1-I4/E1
1. IP Parameters
2. Adapter Parameters
3. Ping Test
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
Selecting the IP (Internet Protocol) parameters option displays the following menu:
IP Parameters
10/100 Mbps Ethernet PCI Adapter II: U1.9-P1-I4/E1
1. Client IP Address
2. Server IP Address
3. Gateway IP Address
4. Subnet Mask
--------------------------------------------------------------------------------------------------
Navigation keys:
M = return to main menu
ESC key = return to previous screen
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigation key: _
To change IP parameters, type the number of the parameters for which you want to change the value.
Entering IP parameters on this screen will automatically update the parameters on the ping test screen.
842 Eserver pSeries 690 Service Guide
Slot
U1.9-P1-I4/E1
U1.5-P2-I3/T1
[000.000.000.000]
[000.000.000.000]
[000.000.000.000]
[255.255.255.000]
Hardware Address
00096baeac10
0009cbce0fde
X = eXit System Management Services
X = eXit System Management Services
X = eXit System Management Services