4. If the new PCI adapter does not extend beyond the mark at the top of the linkage subassembly,
attach the appropriate short card arm card. If the adapter extends beyond this mark, attach the long
card arm to the support arm of the linkage subassembly as follows:
1 Mark at the Top of Linkage
Subassembly
2 Top Rear Clip (Shown on the long,
and short card arms and
middle-spacer arm)
3 Long Card Arm
4 Short Card Arm
Note: Ensure the card arm is fully on the track and clears the end of the support arm of the linkage
subassembly. A flat head screwdriver might be needed to push the card arm in the remaining
distance.
a. Bend the support arm downward, to allow the middle spacer (long cards only) and card arm to
slide onto the end of the support arm.
b. Slide the card arm until the top-rear and lower clips align with the edge of the card.
946
Eserver pSeries 690 Service Guide
5 Short Adapter
6 Top Front Clip
7 Long Adapter