IBM pSeries 690 Service Manual page 667

Error Code Description
406E 0012 Scan control routines detected fault in Memory
book (slot 2)
406E 0013 Scan control routines detected fault in Memory
book (slot 3)
406E 0014 Scan control routines detected fault in Memory
book (slot 4)
406E 0015 Scan control routines detected fault in Memory
book (slot 5)
406E 0016 Scan control routines detected fault in Memory
book (slot 6)
406E 0017 Scan control routines detected fault in Memory
book (slot 7)
406E 00B0 Scan control routines detected possible
problem with bus controller or CSP code
406E 00B1 Scan control routines detected possible
problem with bus controller
406E 00B3 Scan control routines detected MCM 0/VPD
problem
406E 00B4 Scan control routines detected MCM 2/VPD
problem
406E 00B5 Scan control routines detected MCM 1/VPD
problem
406E 00B6 Scan control routines detected MCM 3/VPD
problem
406E 00B7 Scan control routines detected hardware
problem in the processor subsystem
Action/
Possible Failing FRU
Memory book (slot 2)
Location: U1.18-P1-M7
Memory book (slot 3)
Location: U1.18-P1-M6
Memory book (slot 4)
Location: U1.18-P1-M4
Memory book (slot 5)
Location: U1.18-P1-M8
Memory book (slot 6)
Location: U1.18-P1-M5
Memory book (slot 7)
Location: U1.18-P1-M1
1. Check for system firmware updates.
2. Primary I/O book,
Location: U1.18-P1-H2
3. Call service support.
1. Check for system firmware updates.
2. Primary I/O book,
Location: U1.18-P1-H2
3. Call service support.
1. Check for system firmware updates.
2. MCM module 0 and VPD card
Location: U1.18-P1-C1 and
U1.18-P1-H2.3
1. Check for system firmware updates.
2. MCM module 2 and VPD card
Location: U1.18-P1-C4 and
U1.18-P1-H2.4
1. Check for system firmware updates.
2. MCM module 1 and VPD card
Location: U1.18-P1-C3 and
U1.18-P1-H2.5
1. Check for system firmware updates.
2. MCM module 3 and VPD card
Location: U1.18-P1-C2 and
U1.18-P1-H2.6
Go to "MAP 1540: Problem Isolation
Procedures" on page 310.
Chapter 5. Error Code to FRU Index
651