IBM pSeries 690 Service Manual page 370

Hide thumbs Also See for pSeries 690:

Table of Contents

Step 1548-12

Turn on the power.

Step 1548-13

Did the system stop with the same error code as recorded in "Step 1548-1" on page 352?

Go to "Step 1548-14."

The part just replaced was defective. This ends the procedure.

Return the system to its original configuration.

Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information

for Multiple Bus Systems.

Step 1548-14

Turn off the power.

Make sure all amber logic-power LEDs of all installed processor subsystem DCAs are off.

Step 1548-15

Call for support.

This ends the procedure.

Eserver pSeries 690 Service Guide