IBM pSeries 690 Service Manual page 436

8-Digit Error Code What You Should Do
or
4-Digit Checkpoint
8xxx Service Processor Checkpoints
9xxx
Go to "Service Processor Checkpoints" on page 374 for more information on these
Axxx
checkpoints.
Bxxx
A1FD 000x The system has entered recovery mode. Go to "Recovery Mode" on page 824.
B006 xxxx Common Firmware Error Codes
B1xx xxxx
1. There may be additional error codes and information in the service processor error log.
2. Confirm this is the first error code that caused the failure as described in "Confirming
3. Did you come to this step from step 2.
BBxx xxxx pSeries High Performance Switch Error Codes. Go to eServer Cluster 1600: pSeries High
BCxx xxxx Performance Switch Planning, Installation, and Service Guide, order number GA22-7951.
Exxx Firmware Checkpoints
Go to "Firmware Checkpoints" on page 381 for more information on these checkpoints.
Mxxx xxxx Problem Determination-Generated Error Codes
Go to "Problem Determination-Generated Error Codes" on page 770, and follow the
instructions in the error code table.
420 Eserver pSeries 690 Service Guide
The system must be powered off to examine the contents of the service processor error
log.
a. Is the system still powered on?
NO Go to step 2 below.
YES Ask the customer if the system can be powered off, then go to step 1b
below.
b. Can the system be powered off?
NO Go to step 3 below.
YES Power off the system, then go to step 2 below.
Initial Error Code" on page 416.
NO Go to "Common Firmware Error Codes" on page 750 with the error codes you
already have and follow the instructions in the Common Firmware error code
table.
YES Go to "Common Firmware Error Codes" on page 750 with the error code(s)
from step 2 and follow the instructions in the Common Firmware error code
table.