IBM pSeries 690 Service Manual page 468

Error Code Description
101B 7BA6 IBF 3B failure
101B CE16 BPC-BPC communication failure
101B D216 BPA-BPA communication failure
101B D616 Problem with external UPS: utility failure
101B D716 Problem with external UPS: battery low
101B D716 Informational message about the IBF.
101B D766 Informational message about the IBF.
101B D776 Informational message about the IBF.
101B D816 External UPS: bypass active (informational
message)
101B D916 External UPS: power restored (informational
message)
101B DA16 External UPS: installed (informational message)
101B DB16 Problem with external UPS: UPS not available
452 Eserver pSeries 690 Service Guide
Action/
Possible Failing FRU
Go to "MAP 1526: There Is An Integrated Battery
Feature (IBF) Failure" on page 208.
1. Check the cable between the two BPCs;
reseat and look for bent pins.
2. Replace BPC-A, location: U1.35-P1-X4
3. Replace BPC-B, location: U1.35-P2-X4.
Go to "MAP 1520: Power" on page 194 for
isolation.
1. Verify the cabling between the UPS and the
BPCs.
2. Refer to the manufacturer's documentation
for the UPS.
3. Call service support.
1. Verify the cabling between the UPS and the
BPCs.
2. Refer to the manufacturer's documentation
for the UPS.
3. Call service support.
Informational message.
Informational message.
Informational message.
Informational message. If a problem is
suspected:
1. Verify the cabling between the UPS and the
BPCs.
2. Refer to the manufacturer's documentation
for the UPS.
3. Call service support.
Informational message. If a problem is
suspected:
1. Verify the cabling between the UPS and the
BPCs.
2. Refer to the manufacturer's documentation
for the UPS.
3. Call service support.
Informational message. If a problem is
suspected:
1. Verify the cabling between the UPS and the
BPCs.
2. Refer to the manufacturer's documentation
for the UPS.
3. Call service support.
1. Verify the cabling between the UPS and the
BPCs.
2. Refer to the manufacturer's documentation
for the UPS.
3. Call service support.