IBM pSeries 690 Service Manual page 408

Table 2. Firmware Checkpoints (continued)
Checkpoint
E52B
E52F
E530
E531
E532
392 Eserver pSeries 690 Service Guide
Description
The RIO cable connected to the RIO port
has been detected
End of configuration of the RIO hub
Checking I/O hub ports on current I/O hub
Get I/O hub node ID
I/O cable detected; enable the I/O hub port
Action/
Possible Failing FRU
1. Check the RIO cable specified by the
location code. If the location code
specifies an I/O subsystem or its RIO
interface, check the RIO cables going
into and out of the I/O subsystem.
2. Replace the RIO cables specified by
the location code. If the location code
specifies an I/O subsystem or its RIO
interface, replace the RIO cables going
into and out of the I/O subsystem.
3. Replace the I/O book specifed by the
location code, or the I./O book that the
RIO cables in step 1 are attached to.
4. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
5. Replace the I/O subsystem backplane
specified by the location code, or the
I/O subsystem backplane that the RIO
cables in step 1 are attached to.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 320.
1. Check for system firmware updates.
2. Go to "MAP 1542: I/O Problem
Isolation" on page 320.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O book that the failing I/O
subsystem is attached to, U1.18-P1-Hx.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 320.
1. Replace the I/O cable specified by the
location code.
2. Replace the I/O book that the failing I/O
subsystem is attached to, U1.18-P1-Hx.
3. If the location code associated with this
checkpoint specifies a PCI adapter
card, replace the adapter card.
4. Replace the I/O subsystem backplane
that the I/O cable in step 1 is attached
to.
5. Go to "MAP 1542: I/O Problem
Isolation" on page 320.