IBM pSeries 690 Service Manual page 950

Hide thumbs Also See for pSeries 690:

Table of Contents

Replacing a PCI Adapter Cassette:

Perform this procedure only when you are instructed to from "Removing a Non-Hot-Pluggable

PCI Adapter" on page 936 or "Hot-Pluggable PCI Adapter" on page 937. Before you replace the PCI

adapter cassette, check the following:

v Before installing a PCI adapter cassette in the system, an adapter or blank filler must be installed in

each PCI adapter cassette and the top cover for the system must be installed.

v Check the adapter in the cassette that you are about to install, and make sure that the adapter is held

firmly on all four corners by the retaining arms and ratchet clips.

v Review the procedures beginning with "PCI Adapter or Blank Filler Removal from a

Snap-Assembly-Type Cassette" on page 951 to make sure that the adapter is correctly installed in the

To replace a PCI adapter cassette, do the following:

1. Depress the handle release lever located in the center of the PCI adapter cassette handle. Move the

handle down completely to the fully down position. See the following illustration.

2. Push the top of the locking bar in until it clicks into the locked position.

Eserver pSeries 690 Service Guide

1 Cassette Dovetail Rails

2 Handle-Release Lever Latch

3 Handle Release Lever