IBM pSeries 690 Service Manual page 1025

Hide thumbs Also See for pSeries 690:

Table of Contents

1. Align the I/O subsystem backplane assembly with the chassis opening and ensure that the roll bar

clears the top-edge EMC gasket without damaging it.

2. Slide the I/O subsystem backplane assembly into the chassis. Ensure that the two pins in the chassis

align with the bottom of the backplane. Align the backplane with the connector.

3. Continue to slide the backplane in slowly until it makes contact with the connector.

4. Upon contact, insert the insertion tool (part number 11P4789) to cam the backplane into the connector.

5. Pry with the tool until the screw holes on the chassis and the board align.

6. Secure with two screws.

7. Reinstall all adapters and reconnect all cables to the replaced I/O backplane.

Chapter 9. Removal and Replacement Procedures