IBM pSeries 690 Service Manual page 383

Hide thumbs Also See for pSeries 690:

Table of Contents

Step 154A-22

Is the value recorded in "Step 154A-1" on page 363 for word 13 of this error code equal to

0000A218 or 0000A21B?

Go to "Step 154A-5" on page 363.

Go to "Step 154A-23."

Step 154A-23

Replace the following cards and modules, if present, one at a time:

v First location code item recorded, if any, in "Step 154A-1" on page 363.

v Second location code item recorded, if any, in "Step 154A-1" on page 363.

v Primary I/O Book at U1.18-P1-H2 if not recorded in "Step 154A-1" on page 363.

v Component on which you are trying to turn on the identify LED at the location you selected.

Step 154A-24

Turn on the power.

Step 154A-25

Did the system stop with the same error code as recorded in "Step 154A-1" on page 363?

The card or module just replaced was defective. This ends the procedure.

Return the system to its original configuration.

Go to "MAP 0410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostic Information

for Multiple Bus Systems.

Go to "Step 154A-26."

Step 154A-26

Have all the cards or modules listed in "Step 154A-23" been replaced?

Go to "Step 154A-2" on page 363.

Go to "Step 154A-14" on page 365.

Chapter 3. Maintenance Analysis Procedures