IBM pSeries 690 Service Manual page 810

v Power-On System
Allows immediate power-on of the system.
v Power-Off System
This option is not available on this system.
v Enable/Disable Fast System Boot
Allows the user to select the IPL type, mode, and speed of the system boot.
Attention: Selecting the fast IPL results in several diagnostic tests being skipped and a shorter
memory test being run.
v Boot Mode Menu
Note: This option is disabled in partitioned systems.
The Boot Mode Menu allows you to select a boot mode.
Boot Mode Menu
1. Boot to SMS Menu:
Currently Disabled
2. Service Mode Boot from Saved List:
Currently Disabled
3. Service Mode Boot from Default List:
Currently Disabled
4. Boot to Open Firmware Prompt:
Currently Disabled
98. Return to Previous Menu
0>
To select a boot mode, select a number and press Enter. The item corresponding to the selected
number toggles between Disabled to Enabled. If a boot mode is Enabled, the boot mode selected is
performed, and the Disabled/Enabled selection is reset to Disabled. The following describes each boot
mode:
– Boot to SMS Menu
When this selection is enabled, the system boots to the System Management Services (SMS) Menu.
– Service Mode Boot from Saved List
This selection causes the system to perform a service mode boot using the service mode boot list
saved in NVRAM. If the system boots AIX from the disk drive and AIX diagnostics are loaded on the
disk drive, AIX boots to the diagnostics menu.
Using this option to boot the system is the preferred way to run online diagnostics.
– Service Mode Boot from Default List
This selection is similar to Service Mode Boot from Saved List, except the system boots using the
default boot list that is stored in the system firmware. This is normally used to try to boot customer
diagnostics from the CD-ROM drive.
Using this option to boot the system is the preferred way to run standalone diagnostics.
– Boot to Open Firmware
This option should only be used by service personnel to obtain additional debug information. When
this selection is enabled, the system boots to the open firmware prompt.
794 Eserver pSeries 690 Service Guide