IBM pSeries 690 Service Manual page 508

Error Code Description
20D0 0001 I/O subsystem has changed locations
20D0 000F Self-test failed on device, no error and/or
location code information available
20D0 0010 Selftest failed on device, cannot locate
package
20D0 0011 Firmware RTAS attempt to allocate memory
failed.
20D0 0800 Firmware update failure: partition does not
have service authority
20D0 0801 System firmware update failure: more than
one partition running
20D0 0997 Operating system terminated with error string
20D0 0A01 Error initializing RTAS NVRAM
20D0 0A02 Error initializing RTAS debugging token
20D0 0A03 Error initializing interface/service processor
access
492 Eserver pSeries 690 Service Guide
Action/
Possible Failing FRU
This is an informational message.
The I/O subsystem at the location code
associated with this messages was found at
another location code during a prior boot of
the system.
If an I/O subsystem has not been moved,
complete the following steps:
1. Boot the system and match the I/O
subsystem location codes reported by the
operating system to the subsystems
attached to the CEC. Check the SPCN
and RIO cabling to the I/O subsystems. If
a cabling problem is found, correct it.
2. If no cabling problem is found, call your
next level of support.
Refer to "Determining Location Code" on page
417 to see if a location code is available for
the device the error was reported against.
1. Replace device indicated by the location
code (if available).
2. Go to "MAP 1542: I/O Problem Isolation"
on page 320.
Contact your next level of support for
assistance.
Contact your next level of support for
assistance.
Using the HMC, grant service authority to that
partition. Reboot the partition. Retry the flash
update.
Shut down all other partitions, then retry the
firmware update.
Call service support.
A hypervisor dump may be available; see
"Hypervisor Dump Retrieval Procedure" on
page 771.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.
1. Check for system firmware updates. Apply
update if available.
2. Contact your next level of support for
assistance.