Driven Coupling Removal And Installation; Intermediate Drive Shaft Removal - Yamaha Waverunner FX 160 Service Manual

Hide thumbs Also See for Waverunner FX 160:

Table of Contents

BEARING HOUSING

SERVICE POINTS

Driven coupling removal and installation

1. Remove and install:

• Driven coupling

Coupler wrench:

YW-06551/90890-06551

Shaft holder:

Crankshaft holder 20:

• Install the driven coupling with the same spe-

cial tools that were used for removal.

• Check that the shaft holder and intermediate

drive shaft are properly engaged.

• Intermediate drive shaft

Removal steps:

• Temporarily install the driven coupling to

the intermediate drive shaft.

• Insert a long rod to the driven coupling

• Press out the intermediate drive shaft by

pushing the rod.

Support the intermediate housing with steel

blocks 1 and press the driven coupling shaft

with a rod that is more than 210 mm (8.27 in)

long, and which has an outer diameter less

than 16 mm (0.63 in).