Disable Qinq; Show Qinq - D-Link xStack Reference Manual
Dgs-3620 series layer 3 managed stackable gigabit switch
Hide thumbs
Also See for xStack:
- Reference manual (1109 pages) ,
- User manual (357 pages) ,
- Hardware installation manual (71 pages)
Table of Contents
Advertisement
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Example
To enable Q-in-Q:
DGS-3620-28SC:admin#enable qinq
Command: enable qinq
Success.
DGS-3620-28SC:admin#
86-2
disable qinq
Description
This command is used to disable Q-in-Q. When Q-in-Q is disabled, all dynamic learned L2
addresses will be cleared, all dynamic registered VLAN entries will be cleared, and GVRP will be
disabled. To run GVRP on the switch, the administrator should enable GVRP manually.
Format
disable qinq
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable Q-in-Q:
DGS-3620-28SC:admin#disable qinq
Command: disable qinq
Success.
DGS-3620-28SC:admin#
86-3
show qinq
Description
This command is used to display the global Q-in-Q status.
Format
show qinq
994
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the xStack and is the answer not in the manual?
Questions and answers