Configuring Mac Threshold Notification Traps - Cisco Catalyst 9500 Manual

Administering the Device
Step 6
Step 7
Step 8
What to do next
To disable MAC address-move notification traps, use the no snmp-server enable traps mac-notification
move global configuration command. To disable the MAC address-move notification feature, use the no mac
address-table notification mac-move global configuration command.
You can verify your settings by entering the show mac address-table notification mac-move privileged
EXEC commands.

Configuring MAC Threshold Notification Traps

When you configure MAC threshold notification, an SNMP notification is generated and sent to the network
management system when a MAC address table threshold limit is reached or exceeded.
Follow these steps to configure the switch to send MAC address table threshold notification traps to an NMS
host:
Procedure
Step 1
Command or Action
Device(config)# mac address-table
notification mac-move
end
Example:
Device(config)# end
show running-config
Example:
Device# show running-config
copy running-config startup-config
Example:
Device# copy running-config
startup-config
Command or Action
enable
Example:
Device> enable
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
Configuring MAC Threshold Notification Traps
Purpose
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the
configuration file.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
31