Provision ISR Ultra-Z IP series User Manual page 68

11.1) IR LED
In the menu the user can enable and disable the IR LED manually and set up the IR LED
work mode under this OSD mean
:
CONTROL MODE
AUTO IR LEDs turn on or off automatically according to light conditions
TIMING LED is adjusted according to On and Off Times.
OPEN IR LED forcedly open
CLOSE IR LED forcely close
CAMERA IR LED status (Open/Close) will be synchronized with Camera
day and night switching
Here the user can manually set the sensitivity from 1-9. The smaller the
1)
SENSE:
number is, the lower light of the environment will be when the IR LED on
3)
NEAR POWER COMPENSATION:
The default is 100%. Any value lower than 100% will reduce the light of the LED
4)
FAR POWER COMPENSATION:
default is 100%. Any value lower than 100% will reduce the light of the LED
When it is on, the IR LED will turn its power consumption to the
5)
AUTO CONTROL:
standby status which will effectively extend the service life of IR LEDs. And under
this mode, when objects appear in the screen, the IR LED will turn its power
consumption back to the normal status.
set the near power compensation to a value from 0-100%.
set the far power compensation to a value from 0-100%. The
.
75