Provision ISR Ultra-Z IP series User Manual page 25

Network ir ptz camera
Table of Contents

Advertisement

Steps:
1. Enter TCP/IP Settings interface:
Configuration > Advanced Configuration > Network > TCP/IP
2. Configure the NIC settings, including the IPv4 (IPv6) Address, IPv4 (IPv6) Subnet Mask and IPv4 (IPv6)
Default Gateway.
3. Click
to save the above settings
Notes:
 If the DHCP server is available, you can check
and other network settings from that server.
 The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676. The default value is
1500.
 The Multicast sends a stream to the multicast group address and allows multiple clients to
acquire the stream at the same time by requesting a copy from the multicast group address.
 Before utilizing this function, you have to enable the Multicast function of your router and
configure the gateway of the network PTZ.
 If the DNS server settings are required for some applications (e.g., sending email), you should
properly configure the Preferred DNS Server and Alternate DNS server.
Note:
The router must support the route advertisement function if you select Route Advertisement as
the IPv6 mode.
Figure 6-7 TCP/IP Settings
.
Figure 6-8 DNS Server Settings
to automatically obtain an IP address
25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ultra-Z IP series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

This manual is also suitable for:

Z-20ip-1Z-30ip-2Z-30ip-1

Table of Contents