Configuring Video Tampering Alarm - Provision ISR Ultra-Z IP series User Manual

6.6.3 Configuring Video Tampering Alarm

Purpose:
You can configure the PTZ to trigger the alarm actions when the lens is covered.
Steps:
1. Enter the tampering Settings interface:
Configuration > Advanced Configuration > Events > Video Tampering
Figure 6-45 Tamper-proof Alarm
2. Check Enable Video Tampering checkbox to enable the tampering detection.
3. Set the tampering area. Refer to Step 1 Set the Motion Detection Area in Section
6.6.1 Configuring Motion Detection.
4. Click to edit the arming schedule for tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion detection. Refer to
Step 2 Set the Arming Schedule for Motion Detection in Section 6.6.1 Configuring Motion Detection.
5. Check the checkbox to select the linkage method taken for the tampering. Notify surveillance
center, send email and trigger alarm output are selectable. Please refer to Step 3 Set the Alarm
Actions for Motion Detection in Section 6.6.1 Configuring Motion Detection.
6. Click to save the settings.
49