D-Link DXS-3326GSR Reference Manual page 271

delete arpentry
Description
Parameters
Restrictions
Example Usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
DXS-3326GSR:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DXS-3326GSR:4#
config arp_aging
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To configure ARP aging time:
DXS-3326GSR:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DXS-3326GSR:4#
DXS-3326GSR Stackable Gigabit Layer 3 Switch
This command is used to delete a static ARP entry, made using
the create arpentry command above, by specifying either the IP
address of the entry or all. Specifying all clears the Switch's ARP
table.
<ipaddr> − The IP address of the end node or station.
all − deletes all ARP entries.
Only administrator-level users can issue this command.
Used to configure the age-out timer for ARP table entries on the
Switch.
config arp_aging time <value 0-65535 >
This command sets the maximum amount of time, in minutes, that
an ARP entry can remain in the Switch's ARP table, without being
accessed, before it is dropped from the table.
time <value 0-65535> − The ARP age-out time, in minutes. The
value may be set in the range of 0-65535 minutes with a default
setting of 20 minutes.
Only administrator-level users can issue this command.
263