D-Link DXS-3326GSR Reference Manual page 133

create vlan
Restrictions
Example usage:
To create a protocol VLAN:
DXS-3326GSR:4#create vlan v5 tag 2 protocol-ipxSnap
create vlan v5 tag 2 protocol-ipxSnap
Success.
DXS-3326GSR:4#
Example usage:
To create a VLAN v1, tag 2:
DXS-3326GSR:4#create vlan v1 tag 2
Command: create vlan v1 tag 2
Success.
DXS-3326GSR:4#
delete vlan
Purpose
Syntax
Description
DXS-3326GSR Stackable Gigabit Layer 3 Switch
match of the hexidecimal value previously entered . all will
instruct the Switch to examine the total packet header. After a
match is found, the Switch will forward the packet to this
VLAN.
protocol-rarp - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the
packet header is concurrent with this protocol. This packet
header information is defined by the Reverse Address
Resolution (RARP) Protocol.
Each VLAN name can be up to 32 characters. If the VLAN is not
given a tag, it will be a port-based VLAN. Only administrator-level
users can issue this command.
NOTE: A specific protocol VLAN and a user defined protocol VLAN with
the same encapsulation protocol cannot coexist and will result in a Fail!
Message. (For example, if a user creates an Ethernet2 protocol VLAN, the
user can not create a userDefined protocol VLAN with an Ethernet
encapsulation)
Used to delete a previously configured VLAN on the Switch.
delete vlan <vlan_name 32>
This command will delete a previously configured VLAN on the
Switch
125