D-Link DXS-3326GSR Reference Manual page 136

config gvrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DXS-3326GSR:4#config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DXS-3326GSR:4#
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Used to configure GVRP on the Switch.
config gvrp [<portlist> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
This command is used to configure the Group VLAN Registration
Protocol on the Switch. You can configure ingress checking, the
sending and receiving of GVRP information, and the Port VLAN ID
(PVID).
<portlist> − A range of ports to configure GVRP for. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
all − Specifies all of the ports on the Switch.
state [enable | disable] − Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enable | disable] − Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter
states the frame type that will be accepted by the Switch for this
function. Tagged_only implies that only VLAN tagged frames will
be accepted, while admit_all implies tagged and untagged frames
will be accepted by the Switch.
pvid – Specifies the default VLAN ID associated with the port.
Only administrator-level users can issue this command.
128