D-Link DXS-3326GSR Reference Manual page 282

DXS-3326GSR:4#create iproute 10.48.74.121/255.0.0.0 10.1.1.254 1
Command: create iproute 10.48.74.121/8 10.1.1.254 1
Success.
DXS-3326GSR:4#
create iproute default
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
delete iproute
Purpose
Syntax
Description
Parameters
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Used to create IP route entries to the Switch's IP routing table.
create iproute default <ipaddr> {<metric>}
This command is used to create a default static IP route entry to the
Switch's IP routing table.
<ipaddr> − The gateway IP address for the next hop router.
<metric> − Allows the entry of a routing protocol metric entry
representing the number of routers between the Switch and the IP
address above. The default setting is 1.
Only administrator-level users can issue this command.
DXS-3326GSR:4#create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
Success.
DXS-3326GSR:4#
Used to delete an IP route entry from the Switch's IP routing table.
delete iproute <network_address> <ipaddr> [primary | backup]
This command will delete an existing entry from the Switch's IP
routing table.
<network_address> − IP address and netmask of the IP interface
that is the destination of the route. You can specify the address and
mask information using the traditional format (for example,
10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8).
<ipaddr> − The gateway IP address for the next hop router.
[primary | backup] − The user may choose between Primary and
274