Forwarding Database Commands - D-Link DXS-3326GSR Reference Manual

The forwarding database commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
create fdb
create multicast_fdb
config multicast_fdb
config fdb aging_time
delete fdb
clear fdb
show multicast_fdb
show fdb
show ipfdb
config fdb
destination_hit ports
show fdb
destination_hit ports
Each command is listed, in detail, in the following sections.
create fdb
Purpose
Syntax
Description
Parameters
DXS-3326GSR Stackable Gigabit Layer 3 Switch
F
ORWARDING
Parameters
<vlan_name 32> <macaddr> port <port>
<vlan_name 32> <macaddr>
<vlan_name 32> <macaddr> [add | delete] <portlist>
<sec 10-1000000>
<vlan_name 32> <macaddr>
[vlan <vlan_name 32> | port <port>| all]
{vlan <vlan_name 32> | mac_address <macaddr>}
{port <port> | vlan <vlan_name 32> | mac_address <macaddr> |
static | aging_time}
{<ipaddr>}
[<portlist> | all ] {enable | disable]
{<portlist>}
Used to create a static entry to the unicast MAC address
forwarding table (database).
create fdb <vlan_name 32> <macaddr> [port <port>]
This command will make an entry into the Switch's unicast MAC
address forwarding database.
<vlan_name 32> − The name of the VLAN on which the MAC
address resides.
<macaddr> − The MAC address that will be added to the
forwarding table.
port <port> − The port number corresponding to the MAC
destination address. The Switch will always forward traffic to the
specified device through this port. The port list is specified by
listing the lowest switch number and the beginning port number on
that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
D
ATABASE
92
11
C
OMMANDS