D-Link DXS-3326GSR Reference Manual page 337

config ospf all
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example
To configure all of the OSPF interfaces on the Switch with a single group of parameters:
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Used to configure all of the OSPF interfaces on the Switch at one
time.
config ospf all {area <area_id> | priority <value> |
hello_interval <sec 1-65535> | dead_interval <sec 1-65535> |
authentication [none | simple <password 8> | md5 <key_id 1-
255>] | metric <value 1-65535> | state [enable | disable]}
This command is used to configure all of the OSPF interfaces on
the Switch, using a single group of parameters, at one time.
area <area_id> - A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
priority <value> − The priority used in the election of the
Designated Router (DR). A number between 0 and 255.
hello_interval <sec 1-65535> − Allows the specification of the
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and Authorization
Key should be the same for all routers on the same network.
dead_interval <sec 1-65535> − Allows the specification of the
length of time between the receipt of Hello packets from a neighbor
router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead
Interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 > − The interface metric (1 to 65535).
Entering a 0 will allow automatic calculation of the metric.
authentication – Enter the type of authentication preferred. The
user may choose between:
none –
authentication.
simple <password 8> − Choosing this parameter will set a
simple authentication
password of no more than 8 characters.
md5 <key_id 1-255> − Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
metric <value 1-65535> − This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enable | disable] – Used to enable or disable this function.
Only administrator-level users can issue this command.
Choosing this parameter
which includes
329
will require no
a case-sensitive