D-Link DXS-3326GSR Reference Manual page 339

show ospf all
Parameters
Restrictions
Usage Example:
To display the current OSPF interface settings, for all OSPF interfaces on the Switch:
DXS-3326GSR:4#show ospf all
Command: show ospf all
Interface Name: System
Network Medium Type: BROADCAST
Area ID: 0.0.0.0
Priority: 1
DR Address: 10.42.73.10
Hello Interval: 10
Transmit Delay: 1
Authentication: None
Interface Name: ipif2
Network Medium Type: BROADCAST
Area ID: 1.0.0.0
Priority: 1
DR Address: 123.234.12.34
Hello Interval: 10
Transmit Delay: 1
Authentication: None
Total Entries: 2
DXS-3326GSR:4#
create ospf virtual_link
Purpose
Syntax
Description
Parameters
DXS-3326GSR Stackable Gigabit Layer 3 Switch
interfaces on the Switch.
None.
None.
DR State: DR
IP Address: 123.234.12.34/24 ((Link Up)
Metric: 1
Administrative State: Enabled
DR State: DR
Backup DR Address: None
Dead Interval: 40
Retransmit Time: 5
Used to create an OSPF virtual interface.
create ospf virtual_link <area_id> <neighbor_id>
{hello_interval <sec 1-65535> | dead_interval <sec 1-65535> |
authentication [none | simple <password 8> | md5 <key_id 1-
255>]}
This command is used to create an OSPF virtual interface.
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id> − The OSPF router ID for the remote area. This is
a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the remote area's Area Border Router.
IP Address: 10.42.73.10/8 (Link Up)
Metric: 1
Administrative State: Enabled
Backup DR Address: None
Dead Interval: 40
Retransmit Time: 5
331