D-Link DXS-3326GSR Reference Manual page 223

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4# config 802.1x auth_protocol local
Command: config 802.1x auth_protocol local
Success.
DXS-3326GSR:4#
config 802.1x init
Purpose
Syntax
Description
Parameters
Used to initialize the 802.1x function on a range of ports.
config 802.1x init [port_based ports [<portlist | all>] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr}]
The config 802.1x init command is used to immediately initialize
the 802.1x functions on a specified range of ports or for specified
MAC addresses operating from a specified range of ports.
port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization
can then be specified.
<portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the Switch.
mac_based - This instructs the Switch to initialize 802.1x functions
based on the MAC address of a device on a specific port or range
of ports. MAC address approved for initialization can then be
specified.
<portlist> − Specifies a range of ports. The port list is
specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number
of the range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Specifies the MAC address of the
client to be added.
215