D-Link DXS-3326GSR Reference Manual page 345

config route preference
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the route preference value for RIP as 50:
show route preference
Purpose
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Used to configure the route preference of each route type.
config route preference [static | rip | ospfIntra | ospfInter |
ospfExt1 | ospfExt2] <value 1-999>
This command is used to set the route preference value for each
routing protocol listed. A lower value will denote a better chance that
the specified protocol is the best path for routing packets.
The user may set a preference value for a specific route by first
choosing one of the following and then adding an alternate
preference value:
static – Choose this parameter if you wish to configure the
preference value for the static route.
rip - Choose this parameter if you wish to configure the
preference value for the RIP route.
ospfIntra - Choose this parameter if you wish to configure
the preference value for the OSPF Intra route.
ospfInter - Choose this parameter if you wish to configure
the preference value for the OSPF Inter route.
ospfExtT1 - Choose this parameter if you wish to configure
the preference value for the OSPF ExtT1 route.
ospfExtT2 - Choose this parameter if you wish to configure
the preference value for the OSPF ExtT2 route.
<value 1-999> - Enter a value between 1 and 999 to set the route
preference for a particular route. The lower the value, the higher the
chance the specified protocol will be chosen as the best path for
routing packets.
Only administrator-level users can issue this command.
DXS-3326GSR:4#config route preference rip 50
Command: config route preference rip 50
Success.
DXS-3326GSR:4#
Used to display the route preference of each route type.
337