D-Link DXS-3326GSR Reference Manual page 167

config mac_notification ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable port 7 for MAC address table notification:
DXS-3326GSR:4#config mac_notification ports 1:7 enable
Command: config mac_notification ports 1:7 enable
Success.
DXS-3326GSR:4#
show mac_notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the Switch's MAC address table notification global settings:
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Used to configure MAC address notification status settings.
config mac_notification ports [<portlist | all] [enable | disable]
MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
<portlist> Specify a port or range of ports to be configured. The port
list is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC
address table notification on the Switch.
Only administrator-level users can issue this command.
Used to display the Switch's MAC address table notification global
settings.
show mac_notification
This command is used to display the Switch's MAC address table
notification global settings.
None.
Only administrator-level users can issue this command.
159