D-Link DXS-3326GSR Reference Manual page 111

show traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display traffic control setting:
DXS-3326GSR:4#show traffic control group_list 1:1-1:5
Command: show traffic control group_list 1:1-1:5
Traffic Control
Module Group [ports] Threshold
------
1
1
1
1
1
Total Entries: 5
DXS-3326GSR:4#
DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#config traffic control all broadcast enable
Command: config traffic control all broadcast enable
Success.
DXS-3326GSR:4#
Used to display current traffic control settings.
show traffic control {group_list <storm_grouplist>}
This command displays the current storm traffic control
configuration on the Switch.
group_list <storm_grouplist> − Used to specify a broadcast storm
control group. This is specified by listing the lowest switch number
and the beginning port number on that switch, separated by a
colon. Then the highest switch number, and the highest port
number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order.
None.
------------- ---------
1 128
2 128
3 128
4 128
5 128
Broadcast Multicast
Storm Storm
--------- ---------
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
103
Destination
Lookup Fail
--------
Disabled
Disabled
Disabled
Disabled
Disabled