D-Link DXS-3326GSR Reference Manual page 312

Usage Example:
To configure PIM settings for IP interface "System":
DXS-3326GSR:4#config pim ipif System hello 35 jp_interval 70 state
enable
Command: config pim ipif System hello 35 jp_interval 70 state enable
Success.
DXS-3326GSR:4#
enable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
To enable PIM as previously configured on the Switch:
DXS-3326GSR:4#enable pim
Command: enable pim
Success.
DXS-3326GSR:4#
disable pim
Purpose
Syntax
Description
Parameters
Restrictions
Usage Example:
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Used to enable PIM function on the Switch.
enable pim
This command will enable PIM for the Switch. PIM settings must first
be configured for specific IP interfaces using the config pim
command.
None.
Only administrator-level users can use this command.
Used to disable PIM function on the Switch.
disable pim
This command will disable PIM for the Switch. Any previously
configured PIM settings will remain unchanged and may be enabled
at a later time with the enable pim command.
None.
Only administrator-level users can use this command.
304