D-Link DXS-3326GSR Reference Manual page 286

Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing information will
be redistributed to OSPF.
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To add route redistribution settings:
create route redistribute dst rip src
Purpose
Syntax
Description
Parameters
DXS-3326GSR Stackable Gigabit Layer 3 Switch
Route Source
RIP
Static
Local
DXS-3326GSR:4#create route redistribute dst ospf src rip
Command: create route redistribute dst ospf src rip
Success.
DXS-3326GSR:4#
Used to add route redistribution settings for the exchange of OSPF
routes to RIP routes on the Switch.
create route redistribute dst rip src {all | internal | external |
type_1 | type_2 | inter+e1 | inter+e2}] {metric <value>}
This command will redistribute routing information between the
OSPF and RIP routing protocols to all routers on the network that
are running OSPF or RIP. Routing information entered into the
Static Routing Table on the local DXS-3326GSR switch is also
redistributed
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} −
Allows the selection of the protocol of the source device. The user
may choose between:
all – Specifies both internal an external.
internal – Specifies the internal protocol of the source
device.
external - Specifies the external protocol of the source
device.
type_1 - Calculates the metric (for RIP to OSPF) by adding
the destination's interface cost to the metric entered in the
Metric
0 to 16777214
0 to 16777214
0 to 16777214
278
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2