D-Link DXS-3326GSR Reference Manual page 171

The Access Authentication Control commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
enable authen_policy
disable authen_policy
show authen_policy
create authen_login
method_list_name
config authen_login
delete authen_login
method_list_name
show authen_login
create authen_enable
method_list_name
config authen_enable
delete authen_enable
method_list_name
show authen_enable
config authen application
show authen application
create authen server_group
config authen server_group
delete authen server_group
show authen server_group
create authen server_host
config authen server_host
DXS-3326GSR Stackable Gigabit Layer 3 Switch
TACACS, XTACACS and TACACS+ are separate entities and are
NOTE:
not compatible. The Switch and the server must be configured exactly the
same, using the same protocol. (For example, if the Switch is set up for
TACACS authentication, so must be the host server.)
Parameters
<string 15>
[default | method_list_name <string 15>] method {tacacs |
xtacacs | tacacs+ | radius | server_group <string 15> | local |
none}
<string 15>
{default | method_list_name <string 15> | all}
<string 15>
[default | method_list_name <string 15>] method {tacacs |
xtacacs | tacacs+ | radius | server_group <string 15> |
local_enable | none}
<string 15>
[default | method_list_name <string 15> | all]
{console | telnet | ssh | http | all] [login | enable] [default |
method_list_name <string 15>]
<string 15>
[tacacs | xtacacs | tacacs+ | radius | <string 15>] [add | delete]
server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ |
radius]
<string 15>
{<string 15>}
<ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius] {port
<int 1-65535> | key [<key_string 254> | none] | timeout <int 1-
255> | retransmit <int 1-255>}
<ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius] {port
<int 1-65535> | key [<key_string 254> | none] | timeout <int 1-
255> | retransmit <int 1-255>}
163