D-Link DXS-3326GSR Reference Manual page 82

DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#config syslog host 1 severity all facility local0
Command: config syslog host 1 severity all facility local0
Success.
DXS-3326GSR:4#
config syslog host all
Purpose
Syntax
Description
Parameters
Used to configure the syslog protocol to send system log data to a
remote host.
config syslog host all [severity [informational | warning | all] |
facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 |
local7] | udp_port <int> | state [enable | disable]]
The config syslog host all command is used to configure the
syslog protocol to send system log information to a remote host.
all − Specifies that the command will be applied to all hosts.
severity − Severity level indicator. These are described in the
following:
Bold font indicates that the corresponding severity level is
currently supported on the Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational − Specifies that informational messages will be sent
to the remote host. This corresponds to number 6 from the list
above.
warning − Specifies that warning messages will be sent to the
remote host. This corresponds to number 4 from the list above.
all − Specifies that all of the currently supported syslog messages
that are generated by the Switch will be sent to the remote host.
facility − Some of the operating system daemons and processes
have been assigned Facility values. Processes and daemons that
have not been explicitly assigned a Facility may use any of the
74