D-Link DXS-3326GSR Reference Manual page 65

download
Restrictions
Example usage:
To download a firmware file to image_id 1:
DXS-3326GSR:4#download firmware_fromTFTP 10.48.74.121
c:\dgs3324gsr01.had image_id 1
Command: download firmware_fromTFTP 10.48.74.121 c:\dgs3324gsr01.had
image_id 1
Connecting to server............................Done.
Download firmware............................. Done. Do not power off!
Please wait, programming flash..........Done.
Saving current settings to NV-RAM.....Done.
Please wait, the switch is rebooting...
Example Usage:
To download a configuration file from a TFTP server:
DXS-3326GSR:4#download cfg_to TFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_to TFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration............. Done.
DXS-3326GSR:4#
DXS-3326GSR Stackable Gigabit Layer 3 Switch
cfg_fromTFTP - Download a switch configuration file from a TFTP
server.
<ipaddr> − The IP address of the TFTP server.
<path_filename 12> − The DOS path and filename of the
switch configuration file on the TFTP server. For example,
C:\3226S.had.
increment − Allows the download of a partial switch
configuration file. This allows a file to be downloaded that will
change only the switch parameters explicitly stated in the
configuration file. All other switch parameters will remain
unchanged.
The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
57