D-Link DXS-3326GSR Reference Manual page 220

config 802.1x auth_mode
Parameters
Restrictions
Example usage:
To configure 802.1x authentication by MAC address:
DXS-3326GSR:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DXS-3326GSR:4#
config 802.1x capability ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure 802.1x capability on ports 1-10 on switch 1:
DXS-3326GSR:4#config 802.1x capability ports 1:1 – 1:10 authenticator
Command: config 802.1x capability ports 1:1 – 1:10 authenticator
DXS-3326GSR Stackable Gigabit Layer 3 Switch
[port_based | mac_based ports] − The Switch allows you to
authenticate 802.1x by either port or MAC address.
Only administrator-level users can issue this command.
Used to configure the 802.1x capability of a range of ports on the
Switch.
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
The config 802.1x command has two capabilities that can be set
for each port, authenticator and none.
<portlist> − Specifies a range of ports. The port list is specified by
listing the lowest switch number and the beginning port number on
that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list
range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order.
all − Specifies all of the ports on the Switch.
authenticator − A user must pass the authentication process to
gain access to the network.
none − The port is not controlled by the 802.1x functions.
Only administrator-level users can issue this command.
212