Configuring Trunk Group Settings - AudioCodes Mediant 3000 User Manual

SIP User's Manual
Parameter
Tel Profile ID
[TrunkGroup_ProfileId]

18.2.2 Configuring Trunk Group Settings

The Trunk Group Settings page allows you to configure the settings of up to 120 Trunk
Groups. These Trunk Groups are configured in the Trunk Group Table page (see
Configuring Trunk Group Table on page 277).
This page allows you to select the method for which IP-to-Tel calls are assigned to
channels within each Trunk Group. If no method is selected for a specific Trunk Group, the
setting of the global parameter, ChannelSelectMode takes effect. In addition, this page
defines the method for registering Trunk Groups to selected Serving IP Group IDs (if
defined).
Note:

To configure the Trunk Group Settings table:
1. Open the Trunk Group Settings page (Configuration tab > VoIP menu > GW and IP
to IP submenu > Trunk Group submenu > Trunk Group Settings).
2. From the 'Index' drop-down list, select the range of entries that you want to edit.
3. Configure the Trunk Group according to the table below.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 478.
Version 6.4
The Tel Profile ID assigned to the channels pertaining to the
Trunk Group.
Note: For configuring Tel Profiles, refer to the parameter
TelProfile.
You can also configure the Trunk Group Settings table using the ini file table
parameter TrunkGroupSettings (see 'Number Manipulation Parameters' on
page 732).
Description
279
18. GW and IP to IP
November 2011