AudioCodes Mediant 3000 User Manual page 399

SIP User's Manual

To configure classification rules:
1. Open the Classification Table page (Configuration tab > VoIP menu > SBC submenu
> Routing SBC submenu > Classification Table).
2. Click the Add button; the following appears:
The figure above shows an example classification rule that identifies an incoming SIP
dialog to IP Group ID #4, if its source IP address is 10.8.6.15, source port is 5060, SIP
transport is TLS, and matches the Message Condition rule 1. The rule also allows
(whitelist) this SIP dialog.
3. Configure the classification rule as required. For a description of the parameters, see
the table below.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 478.
Parameter
Index
Matching Characteristics
Source SRD ID
[Classification_SrcSRDID]
Version 6.4
Figure 19-16: Classification Table Page
Table 19-4: Classification Table Parameters
Defines the index number of the table row entry.
Selects the SRD ID of the incoming SIP dialog.
The default is -1 (i.e., no SRD is assigned).
Notes:

The SRDs are configured in the SRD table (see 'Configuring
SRD Table' on page 203).

The SRDs are also associated with a port number as defined by
the SIP Interface used by the SRD (see 'Configuring SIP
Interface Table' on page 206).
399
19. Session Border Controller
Description
November 2011